Lucas
05-08-2007, 06:38 AM
Okay, here is the low down:
I boot up Kismet and see my test AP just fine, 128bit WEP encryption so I go and boot up the airoscript. I do 1, scan, get my AP, 2, select my AP, then 3rd when I go and do an attack with either ARP or fakeauth, in the window that is reading packets and capturing ARP packets, it gives me this "the mac address does not match (I believe either the AP or client) and shows this ath1 ether command....so I leave my laptop going for over 1.5 hours and....no ARPs....
Any ideas what might be going on? Using a WG511T.
I boot up Kismet and see my test AP just fine, 128bit WEP encryption so I go and boot up the airoscript. I do 1, scan, get my AP, 2, select my AP, then 3rd when I go and do an attack with either ARP or fakeauth, in the window that is reading packets and capturing ARP packets, it gives me this "the mac address does not match (I believe either the AP or client) and shows this ath1 ether command....so I leave my laptop going for over 1.5 hours and....no ARPs....
Any ideas what might be going on? Using a WG511T.